Desain Optimasi PID Controller Pada Temperatur Heating Furnace Berbasis Ant Colony Algorithm (ACO)

Authors

  • Venda Kusuma Apsari Universitas Darul Ulum
  • Machrus Ali Universitas Darul Ulum
  • Hidayatul Nurohmah Universitas Darul Ulum
  • Rukslin Rukslin Universitas Darul Ulum

DOI:

https://doi.org/10.56795/fortech.v2i2.204

Keywords:

ACO, Heating Furnace, PID Controller, Artificial Intelligence

Abstract

A furnace is a tool for heating materials, oil, and so on, which usually uses gas, coal, and oil as fuel. Temperature is the main parameter that needs to be controlled in order to remain stable, precise, and of course improve fuel efficiency. As technology develops, there are several methods that can be used to control temperatures that are more reliable than conventional controls. The technology is Proportional Integral Derivative (PID) controller. PID controllers have been proven to be the best controllers and are widely used in industry. But to determine the gain from the PID value is still not accurate and can affect temperature stability, the response is also still slow to reach the desired set point. Therefore, this paper is to simulate a better PID gain value by using the artificial intelligence tuning method. The artificial intelligence method is Ant Colony Optimization (ACO). The simulation results and discussion show that the best design is PID-ACO with 0.0081 overshot, no undershot, and the fastest settling time is 35 seconds

 

Author Biographies

Venda Kusuma Apsari, Universitas Darul Ulum

 

 

 

Machrus Ali, Universitas Darul Ulum

 

 

 

 

Hidayatul Nurohmah, Universitas Darul Ulum

 

 

 

Rukslin Rukslin, Universitas Darul Ulum

 

 

 

References

M. Ali and M. Ulum, “Perbandingan Optimasi Kontroler Putaran Motor Permanent Magnet Syschronous Machine,” J. FORTECH, vol. 1, no. 1, pp. 12–19, Feb. 2020, doi: 10.32492/fortech.v1i1.218.

Machrus Ali, H. Nurohmah, Rukslin, Dwi Ajiatmo, and M Agil Haikal, “Hybrid Design Optimization of Heating Furnace Temperature using ANFIS-PSO,” J. FORTEI-JEERI, vol. 1, no. 2, pp. 35–42, Dec. 2020, doi: 10.46962/forteijeeri.v1i2.21.

Machrus Ali, Ruslan Hidayat, and Iwan Cahyono, “Penggunaan ANFIS pada Pengaturan Debit Air Berdasarkan Volume Air Dalam Tangki,” ALINIER J. Artif. Intell. Appl., vol. 1, no. 1, pp. 24–32, Mar. 2020, doi: 10.36040/alinier.v1i1.2519.

Muhammad Agil Haikal, Dandy Tulus Herlambang, Machrus Ali, and Muhlasin, “Desain Optimasi PID Controller Pada Heating Furnace Temperature Menggunakan Metode Particle Swarm Optimization (PSO),” ALINIER J. Artif. Intell. Appl., vol. 2, no. 2, pp. 77–82, Nov. 2021, doi: 10.36040/alinier.v2i2.5162.

M. Ibrahim, D. Ramadhan, and M. Ali, “Optimasi Kontroler Putaran Motor Permanent Magnet Syschronous Machine ( PMSM ) menggunakan PSO-ANFIS ( Studi Kasus di Perumdam Tirta Kencana ),” Jurna; El-Sains, vol. 2, 2020.

A. Parwanti, S. I. Wahyudi, M. F. Ni’Am, M. Ali, Iswinarti, and M. A. Haikal, “Modified Firefly Algorithm for Optimization of the Water Level in the Tank,” in 2021 3rd International Conference on Research and Academic Community Services (ICRACOS), Oct. 2021, pp. 113–116. doi: 10.1109/ICRACOS53680.2021.9701981.

M. Ali, A. N. Afandi, A. Parwati, R. Hidayat, and C. Hasyim, “DESIGN OF WATER LEVEL CONTROL SYSTEMS USING PID AND ANFIS BASED ON FIREFLY ALGORITHM,” JEEMECS (Journal Electr. Eng. Mechatron. Comput. Sci., vol. 2, no. 1, Feb. 2019, doi: 10.26905/jeemecs.v2i1.2804.

Budiman and M. Ali, “Modifikasi Firefly Algorithm Untuk Partial Shading pada Photovoltaic,” ALINIER J. Artif. Intell. Appl., vol. 2, no. 1, pp. 22–27, May 2021, doi: 10.36040/alinier.v2i1.3534.

M. Ali, R. Rukslin, H. Nurohmah, Y. Arie Pambayun, and A. Zaini, “Rekonfigurasi Jaringan Distribusi Radial Di Penyulang Purwoasri Berbasis Modified Imperialist Competitive Algorithms (MICA),” J. FORTECH, vol. 1, no. 2, pp. 74–78, Aug. 2020, doi: 10.32492/fortech.v1i2.227.

M. Ali, T. Fahmi, D. W. Khaidir, and H. Nurohmah, “Optimizing Single Axis Tracking for Bat Algorithm-based Solar Cell,” J. FESPE, vol. 2, no. 2, pp. 1–5, 2020.

Y. G. Hartlambang, H. Nurohmah, and M. Ali, “Optimasi Kecepatan Motor DC Menggunakan Algoritma Kelelawar (Bat Algorithm),” Semant. 2017, Univ. Madura, no. 1, pp. 1–8, 2017, [Online]. Available: http://semantikom.unira.ac.id/2017/SEMANTIKOM_2017_paper_2.pdf

W. Cahyono, M. Ali, and H. Nurohmah, “Ant Colony Optimazation sebagai Tuning PID pada Single Axis Tracking Photovoltaic,” Sinarfe7-2, vol. 2, no. 1, pp. 455–458, 2019, [Online]. Available: https://ejournal.fortei7.org/index.php/SinarFe7/article/view/91

M. N. Masrukhan, M. P. Mulyo, D. Ajiatmo, and M. Ali, “Optimasi Kecepatan Motor DC Menggunakan Pid Dengan Tuning Ant Colony Optimization (ACO) Controller,” SENTIA-2016, Polinema, Malang, no. October, pp. B49–B52, 2016, [Online]. Available: http://sentia.polinema.ac.id/index.php/SENTIA2016/article/view/76

Y. V. P. K. Y V Pavan Kumar, “Cascaded PID Controller Design for Heating Furnace Temperature Control,” IOSR J. Electron. Commun. Eng., vol. 5, no. 3, pp. 76–83, 2013, doi: 10.9790/2834-0537683.

M. Ali, D. Ajiatmo, and M. R. Djalal, “Aplikasi Modified-Imperialist-Competitive-Algorithm (MICA) Untuk Merekonfigurasi Jaringan Radial Tenaga Listrik Pada Penyulang Mojoagung,” JEEE-U (Journal Electr. Electron. Eng., vol. 1, no. 2, pp. 49–53, Oct. 2017, doi: 10.21070/jeee-u.v1i2.1020.

M. Ali, M. A. Haikal, R. Rukslin, and H. Nurohmah, “Optimisasi Steering Control Pada Mobil Listrik Auto-Pilot Menggunakan Metode Bat Algorithm,” JE-Unisla, vol. 7, no. 1, p. 36, Apr. 2022, doi: 10.30736/je-unisla.v7i1.813.

M. Ali and A. Suhadak, “Optimisasi Steering Control Mobil Listrik Auto-Pilot Menggunakan Metode Firefly Algorithm (FA),” Semnasinotek 2017, UN PGRI, Kediri, pp. 61–68, 2017.

G. Y. Hartlambang, M. Ali, and A. Raikhani, “Unjuk Kerja Kecerdasan Buatan (Artificial Intelligence) Dalam Mengoptimalkan Kecepatan Motor Dc Dengan Menggunakan Metode Imperalistt Competitive Alghorithm (ICA),” Intake J. Penelit. Ilmu Tek. Dan Terap., vol. 6, no. 1, pp. 51–67, 2015, doi: https://doi.org/10.32492/jintake.v6i1.48.

M. Ali and M. Muhlasin, “Auto-Tuning Method for Designing Matlab DC Motor Speed Control With PID (Proportional Integral Derivative),” ADRI Int. J. Sci. Eng. Technol., vol. 1, no. 2, pp. 5–8, 2017, [Online]. Available: https://index.pkp.sfu.ca/index.php/record/view/856960

M. R. Djalal, M. Ali, A. Imran, and H. Setiadi, “Modifikasi Desain PID Controller Pada Permanent Magnet Synchronous Motor Dengan Flower Pollination Algorithm,” J. Tek. Elektro ITP, vol. 6, no. 2, pp. 163–169, Jul. 2017, doi: 10.21063/JTE.2017.3133622.

M. Octavian, Ari; Darmawan, Hofman; Nurohmah, Hidayatul; Ali, “Optimasi Dual Axis Tracking Untuk Photovoltaic Berbasis Firefly Algorithm dan Ant Colony Optimization,” SinarFe7, vol. 1, no. 1, pp. 177–182, 2018, [Online]. Available: https://ejournal.fortei7.org/index.php/SinarFe7/article/view/59

Downloads

Published

2021-09-23

How to Cite

Kusuma Apsari, V., Ali, M., Nurohmah, H., & Rukslin, R. (2021). Desain Optimasi PID Controller Pada Temperatur Heating Furnace Berbasis Ant Colony Algorithm (ACO). Jurnal FORTECH, 2(2), 57–62. https://doi.org/10.56795/fortech.v2i2.204